Views: 0 Author: Site Editor Publish Time: 2022-03-30 Origin: Site
After realizing the importance of the iron steel side bar, many people want to install an iron steel side bar by themselves. However, many people are not too clear about how to operate this installation step. A brief introduction will be given below.
What are the preparation steps to install an iron steel side bar?
What are the following steps to install an iron steel side bar?
What are the final steps to install an iron steel side bar?
1. Wash the car first, especially the place where the iron steel side bar touches, be sure to clean it. Two people cooperate and mark the position of the iron steel side bar triangle corresponding to the position of the body triangle truck. Two people buckle the iron steel side bar on the body. The specific position needs to be grasped by yourself, and then use a pen to draw a line on the body along the upper edge of the iron steel side bar. This line is important and will be used later.
2. Then, the iron steel side bar is treated: the iron steel side bar is uniformly sprayed with an adhesive accelerator, and then dried for 10 minutes before proceeding to the next step. After 10 minutes of drying, touch it without touching it, and then start to stick 3M double-sided tape on the outer edge of the iron steel side bar, 1 cm wide. The other two sides of the iron steel side bar are pasted in two layers. Because the two sides are angled, it is not easy to fit the body, and thicker ones are easy to install.
1. Then, put two layers of glass glue on the side iron steel side bar. It should not be too much, it will waste, and it is not easy to install. Cut off the 2 fixing frames of the side skirts, these 2 fixing devices are not used in this method.
2. Then, install the slide line in the third step just now to buckle the side skirts on the car body, first let the glass glue stick on the car body, and then tear off the 3M double-sided tape little by little. This step requires two people to cooperate. If it is in place, if it is not installed, it will be too late to regret. I reiterate that the third step is important to draw the line. The fifth step is to install the line for installation. After the body is fastened, the amount of movement is small, and the iron steel side bar can only be used. Small adjustments.
1. Then drill the eye, then screw the screw into the iron steel side bar, remember to put the glue in, so that it is waterproof, the inside of the car is full of glue, and it is estimated that it will not rust in 10 years. Put the side iron steel side bar on it and push it in one direction. After installing it, screw two screws with pads underneath to make it firmer.
2. Finally, heat the iron steel side bar with a baking lamp. After 10 minutes, the side skirts should become a bit soft. Press the side skirts hard to make them fit. After pressing, the iron steel side bar will be shaped, and it will be finished when it cools down.
After reading this article, do you have a clearer understanding of installing an iron steel side bar? WEIBO Auto Accessories Co., Ltd. has been focused on the iron steel side bar for several years. They will make every effort to meet the needs of users.
